Filter
Top Products
Replacing the cassette ribbon
Two types of ribbons are available:
Ribbon Types Brother Model
Correctable film ribbon t 030 / 1230
Nylon ribbon i 1032
To replace the cassette ribbon:
1) Use [SPACE BAR] or Hto move the carrier to the
centre of the platen,
2) Open the top cover.
3) Holding the cassette with both hands, lift the front of
the cassette up and out.
4) Move the cassette towards the platen to remove it.
5) Turn the feed knob (on the left side of the cassette)
counter-clockwise to tighten the ribbon in the new
cassette.
6) Align the arrow on the cassette with the arrow on the
cassette holder. Use both hands to ease the cassette
into the holder, back first.
7) Gently press down on the front of the cassette until it
clicks into place.
8) Again turn the feed knob counter*clockwise to take up
any slack.
9) Close the top cover.
10) Press _ +//to move the carrier to the previous
position.
The amount of tape remaining can be checked
,through the viewing hole on the right side of the
cassette.
Make sure to use only Brother-authorized cas-
sette ribbons, correction tapes and cassette daisy
wheels. Brother cannot be held responsible for
difficulties caused by the use of unauthorized
supplies.
Note; Please do not touch the keyboard during replacing the daisy wheel, cassette J
ribbon or correction tape in order to avoid carrier movement.
I
-Page i0-