Brother HL-2060 Printer User Manual


 
CHAPTER 2 GETTING STARTED
2–17
Turning the Printer On and Off
Plugging in the Power Cord
Plug in the power cord as follows:
1.Make sure that the POWER switch is OFF “O”: the switch is on the
front right hand side of the printer.
2.Attach the power cord to the printer and plug it into an appropriate
AC outlet.
Fig. 2-18 Plugging in the Power Cord
!
Caution
Check the AC voltage. This printer should be operated at the specified
voltage and frequency.
• USA and Canada: AC 110 to 120 V, 50/60 Hz
• Europe and Australia: AC 220 to 240 V, 50/60 Hz
Since this printer must be electrically grounded, the power cord
should be connected to a grounded AC outlet.
The total length of the power cord, including extension cords, should
not exceed 5 meters (16.4 feet). Use of a longer power cord may result
in reduced voltage or malfunctions.
Do not unplug the power cord to turn off the printer.
The printer should be installed near a power outlet which is easily
accessible.