Brother FAX-236 Fax Machine User Manual


 
4 - 4
INITIAL SETUP
Setting Beeper Volume
You can set the beeper to LOW, MED, HIGH or OFF. The default setting is LOW.
When the beeper is set to LOW, MED or HIGH, the fax machine beeps every time you
press a key or make an error, and at the end of fax sending or receiving.
1
Press Function/Set, 1, 3.
2
Press or to select your setting and press Function/Set.
3
Press Stop to exit.
Setting the Speaker Volume
You can adjust the speaker volume when your fax machine is on hook (after you
pressed Hook or Speaker Phone), by selecting a speaker volume level.
Press or to adjust the volume level. The display shows the setting you are
choosing. Each key press changes the volume to the next setting. The new setting will
remain until you change it again.
Setting the Ring Volume
You can adjust the ring volume when your fax machine is idle. You can select a ring
volume level or press until the ring is off.
Press or to adjust the volume level. With each key press, the fax machine
rings so you can hear the current setting and the display shows the setting you are
choosing. Each key press changes the volume to the next setting. The new setting will
remain until you change it again.
Memory Storage
In the event of a power failure, all settings in the INITIAL SETUP, SETUP
RECEIVE, SET QUICK-DIAL and SETUP MSG CTR plus the COVERPG SETUP
(FAX-236/335MC only) and COVERPAGE NOTE (from SETUP SEND) (FAX-236/
335MC only) functions are stored permanently. You may have to reset the date and
time.
If you have FAX-335MC, you can adjust the speaker volume while you are listening
to your OGM (Outgoing Message) and ICMs (incoming messages).
If you turn Incoming Recording Monitor to OFF (Function/Set, 8, 5) on the
FAX-335MC, the Speaker for screening calls will be disabled and you wont hear
callers leaving messages. The volume for other operations can still be controlled
using and .