Brother HL-3140CW Network Card User Manual


 
Configuration methods
12
2
One push configuration using WPS (Wi-Fi Protected Setup) 2
If your mobile device supports WPS (PBC; Push Button Configuration), you can configure a Wi-Fi Direct
network by following these instructions.
a Press .
b Press Wi-Fi Direct.
c Swipe up or down, or press a or b to display Group Owner.
Press Group Owner and then press On.
d Swipe up or down, or press a or b to display Push Button.
Press Push Button.
e When Wi-Fi Direct On? is displayed, press On to accept.
To cancel, press Off.
f When Activate Wi-Fi Direct on other device. Then Press [OK]. is displayed, activate
your mobile device's WPS one push configuration method (see your mobile device's user's guide for
instructions) and then press OK on your Brother machine. This will start the Wi-Fi Direct setup.
To cancel, press .
g If your mobile device connects successfully, the machine shows Connected.
You have completed the Wi-Fi Direct network setup. For details on printing from or scanning to your
mobile device, download the Mobile Print/Scan Guide for Brother iPrint&Scan or the AirPrint Guide from
the Brother Solutions Center (http://solutions.brother.com/).
If the connection fails, see Troubleshooting on page 16.