Filter
Top Products
12
English: HL-YL Quick Setup Guide, Body
Installing the Remote Printer Console
Before you install the program, make sure that you have the following hardware and
software:
DOS Version 3.3 or later
Monitor EGA/VGA or compatible
Option Mouse; the mouse driver must be installed.
(You can also operate the program with the keyboard.)
Follow these steps to install the remote printer console program:
1. Make sure your printer is connected to your computer and is ready (On-line).
2. Start your computer. If you are in Windows, exit and return to the DOS prompt. You must
be in the DOS prompt to proceed with installation.
3. Insert the supplied disk into your floppy disk drive (A: or B:).
4. Select drive A or B to be used by typing
A: or B: after the DOS prompt and
pressing the Enter key.
C:\>A:
5. Type RPCSETUP and press the Enter
key.
A:\>RPCSETUP
6. Follow the instructions on the screen.
Using the Remote Printer Console Main Program
Type C:\RPCX>RPCX and press the Enter
key to start the Remote Printer Console
main program.
The Main Screen will appear on your
computer screen as shown on the right.
Remote Printer Console
Direct_Access Printer_Setup Console_Config Guide
Current Status
Status Ready
Media Type Regular
Emulation Auto
Paper Size Letter
Orientation Portrait
Quality Normal
Copies 1
Memory Size 1048576 Bytes
[
↑
/
↓
] Select
[Enter]Setting
[Alt+Character] Menu [F1] Help
[Esc] Exit
The RPC gets the current settings information from your printer when it starts if bi-
directional communication is enabled between your computer and printer. Otherwise, RPC
shows its default settings. If you want to change settings, move the cursor to the desired item
and select the desired setting by using the Enter and Cursor keys. Then, press the Enter key to
make the selected setting valid. If you use a mouse, click the desired item to change the
setting.