Filter
Top Products
UNINET IMAGING INC. • BROTHER HL 1240/165 (TN 430/460) CARTRIDGE REMANUFACTURING INSTRUCTIONS
3. On the same side and with the help of a small jeweler screw-
driver release the three (3) clips holding the developer roller
bearing cap to the toner hopper. The first clip is right below the
screw holding the developer blade, the opposite clip is between
the side of the roll and the casing while the third one is accessi-
ble from outside the casing.
NOTES
1. With the use of small flat blade screwdriver, slightly pry up the
white plastic alignment hub located from the non-gear side of
the developer roller and remove it.
2. NOTE: Be aware of the pressure spring behind the white plas-
tic hub and do not lose it.
© 2007 UniNet Imaging Inc. All Trademark names are property of their respective owners. Product brand names mentioned are intended to show compatibility only. UniNet Imaging does not guarantee or warrant downloaded information.
www.uninetimaging.com/technical.asp
11124 Washington Blvd., Culver City, California USA 90232 • Ph +1 310 280 9620 • Fx +1 310 280 0533 • techsupport2@uninetimaging.com