Brunton 15 Power Supply User Manual


 
5
the unit is being charged the green LED’s will remain illuminated until the battery pack
is fully charged.
SPECIFICATIONS
IX. Battery Supply
X. Charge Input Jack
• The inlet will accept any 2.5 mm by 5.5 mm barrel jack.
• Charge input is rated for 11V DC to 16V DC.
XI. FCC
This device complies with Part 15 of the FCC Rules. Operation is subject to the fol-
lowing two conditions: (1) This device may not cause harmful interference, and (2) this
device must accept any interference received, including interference that may cause
undesired operation.
Note:
This equipment has been tested and found to comply with the limits for a Class B digi-
tal device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy. If not installed
and used in accordance with the instructions, it may cause harmful interference to
radio communications. However there is no guarantee that interference will not occur
Internal Battery Type Lithium Iron Phosphate (LiFePO4)
Internal nominal battery Voltage 12.8 Volts
Internal battery capacity 5.6 Amp Hours for Solo 7.5 & 12.8 Amp Hours for
Solo 15
Expected cycle life to 70% of original capacity 1000 cycles
Current Rating 3 Amps nominal, 5 Amps peak
Wall Transformer
Input Voltage 110 Volt AC
Output Voltage 16 Volt
Output Current 3.36 Amps
Power 54 Watts