Brunton 7.5 Power Supply User Manual


 
7
connected to.
3. Check to see if the connected device is switched on.
4. Press the LEVEL key. If none of the green LED’s light up the battery needs to be
charged or reset. See fault mode above.
5. Check to make sure device does not exceed the power rating of the power pack.
(12.8 volts / 5 amps)
6. Ensure that the charger / device is plugged in to the correct jack.
Problem: Run time is shorter than expected
1. Device being operated may exceed the power pack’s power rating.
2. The battery may not be fully charged. See charging on page 3.
BRUNTON, Limited Warranty
Brunton warrants this product to be free of defects in materials and workmanship, for
a period of one year. This warranty extends to the original purchaser for one year from
the date of purchase.
This Warranty is void and a charge for repair will be made if the Solo has been dam-
aged by negligence, accident or mishandling, or has not been operated in accordance
with standard operating procedures, or if the Solo was altered or repaired by other
than a Brunton repair facility.
This warranty gives you specic legal rights, and you also have rights, which vary
from state to state. No other warranty, expressed or implied, applies to the Brunton
product, nor is any person or company authorized to assume any other warranty for
Brunton. Brunton does not assume any responsibility for any consequential damages
occasioned by this product. Should the product prove defective, contact Brunton,
and you will be provided with a Return Authorization Number (RA#). Send a copy of
your proof of purchase, the RA#, a short description of the problem and the product
to Brunton at the following address. Brunton suggests insuring the product in case of
damage or loss in shipment.
Brunton
Warranty Repair (307) 857-4700
2255 Brunton Court support@brunton.com
Riverton, WY 82501 www.brunton.com