Filter
Top Products
24
Disk Management (RAID Setup)
This page shows your current RAID arrays. You may delete
old arrays or create new ones by clicking on the underlined
RAID Array # under RAID Array Conguration.
The RAID Scanning Settings set a specic time for the
TeraStation to scan and inspect its RAID arrays. It is
recommended to set a time where the TeraStations
usage will be minimal (perhaps the middle of the night).
TeraStation will be signicantly slower while the RAID
scan occurs. Begin Immediate RAID Scan species the
TeraStation to run a RAID Scan immediately.
You may also disable RAID Array Error Detection Response from this page. Normally, this is set to
automatically shut down the RAID array when an error is detected. Though it is not recommended,
you may disable that behavior by selecting Disable.
NOTE: TeraStation has four internal hard drives. Before creating a new RAID array, you may have
to delete one or more pre-existing RAID Arrays to clear up the hard drives for your new one. This
will destroy all data currently on the disks, so back up any important data before deleting RAID
arrays. Whether you want to clear out an old array or create a new one, begin by clicking on the
array’s underlined RAID Array #, under Name.
Conguration GUI