Buffalo Technology WLI-U2-SG54HG Network Card User Manual


 
35
Important Note:
FCC Radiation Exposure Statement: This equipment complies with FCC radiation exposure
limits set forth for an uncontrolled environment. This equipment should be installed and
operated with minimum distance 20cm between the radiator & your body.
This device and its antenna(s) must not be co-located or operating in conjunction with any
other antenna or transmitter.
The availability of some specic channels and/or operational frequency bands are country
dependent and are rmware programmed at the factory to match the intended deestination.
The rmware setting is not accessible by the end user.
IC Caution:
Operation is subject to the following two conditions: (1) this device may not cause interference,
and (2) this device must accept any interference, including interference that may cause
undesired operation of the device. To reduce potential radio interference to other users,
the antenna type and its gain should be so chosen that the equivalent isotropically radiated
power (EIRP) is not more than that required for successful communication. This device
has been designed to operate with an antenna having a maximum gain of 2.0 dBi. Antenna
having a higher gain is strictly prohibited per regulations of Industry Canada. The required
antenna impedance is 50 ohms. To reduce potential radio interference to other users, the
antenna type and its gain should be so chosen that the equivalent isotropically radiated
power (e.i.r.p.) is not more than that permitted for successful communication.
FCC / CE / R&TTE