Filter
Top Products
Chapter 2 Remove Bezel, Cover, and Components
14
Lighten the NetServer
Before you lift the NetServer, remove the hot-swap hard disk drives and power
supply modules. This will lighten the NetServer, so that fewer people will be
needed to lift it.
WARNING Do not attempt to lift the NetServer by yourself. Follow all
local regulations when moving the NetServer.
Failure to observe this warning could result in serious injury to
personnel or damage to the NetServer.
Take out power supplies and hot-swap hard disk drives before
lifting the NetServer.
The HP NetServer LH 3r weighs up to 115 pounds (73 kg)
when fully loaded. The HP NetServer LH 4r weighs up to
176 pounds (80 kg) when fully loaded.
The HP NetServer LH 3000r weighs up to 118 pounds (54 kg)
when fully loaded. The HP NetServer LH 6000r weighs up to
180 pounds (80 kg) when fully loaded.
Remove Hot-Swap Hard Disk Drives
CAUTION Wear a wrist strap and use a static-dissipating work surface
connected to the chassis when you remove or install hot-swap
disk drive modules.
1. Refer to Figure 2-3. To unlock the drive, push the locking latch in and then
pull the ejector handle toward you.
2. Gently pull the drive out about an inch to disengage the power connection.
3. Use your hand to support the bottom of the drive. Slowly pull the drive
straight out. Do not allow the drive to fall.
4. Place the drive in an electrostatic-protected container or on an electrostatic-
protected surface. Do not stack drives.