Filter
Top Products
Chapter 4: The System Level Screen
Page 4-4 ESXMIM/ESXMIM-F2 Local Management Guide
3. Press ENTER to set the system clock.
4. Use the arrow keys to highlight the SAVE command field at the
bottom of the screen and press ENTER.
If the time entered was a valid format, the Event Message field at the
top of the screen displays “SAVED OK”. If the entry was not valid,
Local Management does not alter the current value and refreshes the
System Time field with the previous value.
4.4 SETTING THE HOST IP ADDRESS
To set the host IP address, perform the following steps:
1. Use the arrow keys to highlight the Host IP Address field.
2. Enter the IP address using Decimal Dotted Notation (DDN) format.
For example: 134.141.25.17
3. Press ENTER. If the IP address entered was a valid format, the cursor
returns to the beginning of the Host IP Address field. If the entry was
not valid, the Event Message field displays “INVALID IP ADDRESS
OR FORMAT ENTERED”. Local Management does not alter the
current value and refreshes the Host IP Address field with the previous
value.
4. Use the arrow keys to highlight the SAVE command field.
5. Press ENTER. The Event Message field at the top of the screen
displays “SAVED OK”. This message flashes briefly, then the Event
Message line will display “System Reboot in Progress...”. Local
Management will be terminated and the screen will freeze while the
ESXMIM resets.
NOTE
Changing the ESXMIM IP address requires a reset of the
module. LM will automatically reset the ESXMIM, which will go
through startup operations before bridging will resume.