Canon IP 1000 Printer Accessories User Manual


  Open as PDF
of 4
 
3、Installation Procedures:
Step1 Preparation
Put the CISS on the left side of the printer. Pull out the small rubber plug from the Place 4 pcs of air filters into air holes.
and place all the tubes at correct position. air hole as the picture shown above.
Step 2 Take out the original cartridges
Turn on power Open the printer cover, move the cartridge Then turn off the printer and unplugg
Carriage to “cartridge replace position”,
And take out the original cartridges
Step 3. Set up the Continuous Ink Supply System
Close the cartridge cover Remove the cartridge bottom cap. And put Fix the supporting arm as the picture shows.
the CIS cartridges into cartridge Carriage. Measure 11 cm from the right edge of printer,
1 cm from the below edge, which forms an
angle of 60°.
Place the tube through supporting arm. Move the cartridge car to left end and right end. Make sure that the tubes are not too tight or too
loose.
PDF 文件使用 "pdfFactory Pro" 试用版本创建 www.fineprint.cn
 previous