Filter
Top Products
Adit 3104 - Release 1.6 19
Quick Start
Web-Based Management
Web-Based Management
The web-based management interface allows you to control various system parameters. The interface
is accessed through a web browser.
To access the management console:
NOTE: The following assumes that you have connected the PC to the LAN port of the Adit
3104.
1. Launch a web browser on your PC in the LAN to which the Adit 3104’s LAN port is connected.
Note: If connection to the 3104 is to be through an Ethernet or T1 WAN, the remote admin
WAN access must be enabled with the following command sequence:
2. Type the Adit 3104’s IP address or name in the address bar.
Example: http://192.168.1.1.
z Default IP address is http://192.168.1.1
Note: to display the current IP address of the systems, use the following CLI command:
#show interface ethernet 1 (LAN)
#show interface ethernet 2 (Eth WAN)
3. Login to the unit.
Enter User Name and Password. Note: these setting should be changed from the default settings
after the initial login.
z Default user name is admin
z Default password is admin 123
NOTE: After a few minutes of inactivity, the session will automatically timeout and the
operator will be required to log in to continue the session.
WARNING! IF YOUR USER NAME AND PASSWORD ARE SET TO THE DEFAULT SETTING, IT IS
RECOMMENDED THAT YOU MODIFY THEM FOR SECURITY PURPOSES.
Command Description
Username: admin
Password: ********
Log into the system (username and password).
Adit 3104> enable Enter the Privileged mode.
Password: ******** Enter password for the Privileged mode.
#configure terminal Enter the Configuration mode.
(config)# remote-admin web
primary-port enable
Enable remote web admin.