Filter
Top Products
Operation Guide DQR-300U
2
• A sticker is affixed to the glass of this clock when you purchase it. Be sure to remove the sticker before using the
clock.
• Depending on the clock model, the configuration of your clock may differ somewhat from that shown in the
illustration.
Alarm Off Alarm On
• In locations subject to radio frequency interference, the product may malfunction and require you to reset the
product.
Alarm on
indicator
PM indicator
Wave OK indicator
Antenna Icon
Current Humidity
Upcomimg weather
indicator
Current time
(Hour, minutes, seconds)
Day of the week
DATE (month - date)
Current Temperature
Snooze on indicator
Alarm time
GENERAL GUIDE
Main unit
1SNOOZE/LIGHT button
• Press this button to illuminate the display for about four seconds.
• Pressing this button while the alarm is sounding stops the alarm.
2Alarm Time Set buttons
Use these buttons to change the alarm time or current time setting.
3SET button
Use this button when setting the current time.
4WAVE button
Press this button to receive the time calibration signal and adjust timekeeping.
5Alarm Mode selector
SNZ: Snooze alarm on
ON: Alarm on
OFF: Alarm off
6RESET button
Press this button to reset the clock after replacing its batteries.
7MAX/MIN TEMP. button
Press this button to display the high and low temperature values.
8MAX/MIN HUMIDITY button
Press this button to display the high and low humidity values.
9CLEAR button
Press this button to clear the currently displayed high/low temperature or humidity.
0°C/
°F button
Press this button to toggle the temperature units between Celsius and Fahrenheit.
ARE-SYNC button
Press this button to re-synchronize the timing of the main unit and the sub-unit.
BSELECT button
Press this button to toggle the display between main unit (INDOOR) and sub-unit (OUTDOOR) data.
Sub-unit
CSELECT button
Press this button to toggle the display between the current temperature and humidity.
DRESET button
Press this button to reset the sub-unit after replacing its batteries.
ETEST button
This button is for testing the unit. Normally, you should not press it. If you do, be sure to press the RESET
button (D) next.
F°C/
°F button
Press this button to toggle the temperature units between Celsius and Fahrenheit.