Casio MA1003-B Projector User Manual


 
36
System Admin > Setup Settings
System Admin Page Settings
Setting Name Description
IP Setup IP Address Specifies the projector IP address.
Initial Default: 192.168.100.10
Subnet Mask Specifies a subnet mask value, which specifies the IP address range of the subnet
to which the projector belongs.
Initial Default: 255.255.255.0
Default Gateway Specifies the IP address of the device used as a gateway for access from a
computer outside of the network to which the projector belongs.
Initial Default: 192.168.100.10
DHCP Setup Auto/Disable Specifies whether an IP address should be assigned automatically to a computer
connected to the projector via wireless LAN. “Auto” causes an IP address to be
assigned automatically, while “Disable” turns off auto assignment.
Initial Default: Auto
Starting IP Address Specifies the start point of the range of IP addresses that are assigned
automatically to computers. This setting is available only while “Auto” is selected
for the DHCP Auto/Disable setting.
Initial Default: 192.168.100.11
Ending IP Address Specifies the end point of the range of IP addresses that are assigned
automatically to computers. This setting is available only while “Auto” is selected
for the DHCP Auto/Disable setting.
Initial Default: 192.168.100.254
Wireless Setup SSID Wireless network ID name. This is normally referred to as the SSID, ESS-ID, or
network name. Up to 24 single-byte alphanumeric characters can be entered.
Initial Default: casiolpj_default1 (casiolpj_default2 and casiolpj_default3 also are
built into the projector.)
SSID Broadcast Specifies whether SSID information broadcasting is enabled or disabled.
Initial Default: Enable
Channel Specifies the channel used for wireless LAN communication. Selecting “Auto”
causes auto selection of a channel that is appropriate for the current
communication environment. To specify a channel number, select channel number
1 through 11 from the list that appears when you click the [
] button to the right of
the channel number.
Initial Default: Auto
Security Specifies the security protocol. For more information, see “To configure security
settings” (page 21).
Initial Default: WPA-PSK AES
Passphrase/WEP
Key
Specifies the passphrase or WEP key in accordance with the security protocol
selected with “Security” above. For more information, see “To configure security
settings” (page 21).
IEEE 802.11n Specifies whether wireless LAN standard IEEE 802.11n is enabled.
Initial Default: Enable
Channel Width Specifies either “20MHz” or “Auto” for the IEEE 802.11n channel width.
Initial Default: 20MHz
Show User Name Display Specifies whether the computer’s user name should appear on the projection
screen when projection starts from a computer connected to the projector via
wireless LAN.
Initial Default: On (User name displayed.)