Filter
Top Products
10
E
Part-1 QUICK START OPERATION
1. To load journal paper
!
Remove the printer cover by
lifting up the back.
@
Put a roll of journal paper
into the holder.
#
Cut the leading end of the
roll paper with scissors and
insert the paper into the inlet.
$
Press the
l
key until 20 or
30 cm of paper is fed from
the printer.
%
Roll the paper onto the take-
up reel a few turns.
^
Set the left plate of the take-
up reel and place the reel
into the register.
*
Load new paper following the
instructions above, and re-
place the printer cover.
&
Press the
l
key to take up
any slack in the paper.
*
Replace the printer cover by
placing the cover’s front tab
into the register’s groove.
2. To remove journal paper
!
Remove the printer cover fol-
lowing the instructions above.
@
Press the
l
key until ap-
proximately 20cm of the pa-
per is fed from the printer.
#
Cut off the roll paper.
$
Remove the take-up reel
from the printer and take off
the left plate of the reel.
%
Remove the journal paper
from the take-up reel.
^
Cut off the paper left in the
printer and press the
l
key
until the remaining paper is
fed out from the printer.
&
Remove the core of the pa-
per.
2. Loading Paper Roll And Replacing The Printer’s Ink Roll
Mode Switch
REG
OFF
RF
PGM
CAL
Z
X
◗
To load receipt paper
!
To use the printer to print re-
ceipts, follow steps 1 through
4 of “To load journal paper”.
@
Pass the leading end of the
receipt paper through the
printer cover’s paper outlet
and replace the printer cover.
#
Tear off any excess paper.
Default printer setting is for
Journal.To print receipts, please
refer to 1-7-3 on page 22 to
switch the printer for Receipt or
Journal.
Options: Roll paper – P-5860
Ink Roll – IR-40