Filter
Top Products
12
E
Part-1 QUICK START OPERATION
8. Basic Programing for QUICK START
A) Enter
?X
and press
/
.
B) Select your state.
SELECT YOUR STATE OR
COUNTRY AND ENTER
NUMBER THEN PRESS
<HELP> KEY.
0101:ALABAMA
0201:ALASKA
5001:WISCONSIN
5101;WYOMING
5201:PUERTO RICO
1)TURN MODE KEY TO PGM.
2)3<SUBTOTAL>
3)025<SUBTOTAL>
SET TABLE 1
4)XXXX<CA>KEY.
SET TABLE2(IF NECESSARY)
5)XXXX<CA>KEY.
6)<SUBTOTAL>
XXXX IS DISTRICT NUMBER
Find
your state
your state number.
?Z?Z
/
8-1 Choose the tax rate from a preset tax table.
C) Enter your four digit state number and then
press
/
.
Follow
these steps
8-2 Input the desired flat tax rate to the appropriate department key. (This
procedure below programs flat tax rate only. If your tax table has break
points, refer to page 25 of this manual.)
A) Turn the mode switch to PGM position.
B) Enter
Z
and press the key.
C) Press the
~
key.
D) Enter tax rate. (Example: For 6% enter “6”, 5.75% enter “5.75”.)
E) Press the appropriate department key.
F) Repeat step B) and C) to set other department key.
G) Press the
key to end tax programming.
Note: In case of setting the wrong tax rate to the key, please enter
?
and press those department keys
above, and quit this procedure by pressing
key, and start from the beginning of this procedure.
Please start with the department 2 key (taxable department). Department 1 key is initialized as non tax-
able.
Note : For canadian tax system, see page 25 for more information.
Example 1:
Set state tax 4% to department 2, 3 key.
~
Start tax program.
4
Enter tax rate and press dept key.
4
Enter tax rate and press dept key.
To end the setting.
Example 2:
Set state tax 5% to department 2 and 7% to
department 3 key.
~
Start tax program.
5
Enter tax rate and press dept key.
7
Enter tax rate and press dept key.
To end the setting.