Filter
Top Products
23
To turn password protection on and off
1.
Display the Power On Password setting screen by performing steps 1 through 5
of the procedure under “To change the password” on page 22.
At this time, make sure that “Power On Password” is selected on the Power On Password
setting screen.
2.
Use the [] and [] keys to select “On” or “Off”.
Changing the power on password setting from “Off” to “On” causes the confirmation dialog
box shown below to appear.
Press the [ENTER] key to confirm that you want to turn on power on password protection, or
[ESC] to exit the dialog box without doing anything.
3.
After you are finished, press the [MENU] key to exit the setup menu.
Entering the Password when Turning On the Projector
When you turn on the projector while password protection is turned on will cause a password input
dialog box to appear on the projection screen. All projector operations will be accessible to you after
you input the correct password and press the [ENTER] key.
Note
You can perform the projection size adjustment operation ([ZOOM +] / [ZOOM –] keys), focus
operation ([FOCUS ] / [FOCUS ] keys), and power off operation ([P] (Power) key) while the
password input dialog box is on the projection screen.