Filter
Top Products
38
Wired LAN Settings Main Menu (USB Port Models Only)
USB Settings Main Menu (USB Port Models Only)
The USB Settings main menu is available only when there is an external device connected to the
USB-A port of the projector. For details, see “USB Function Guide” and “Wireless Function Guide” on
the bundled CD-ROM.
Setting Name Input Setting Unit Description
Remote on
RCVHDUN
Single Specifies whether the projector can be turned on via wired LAN
while the projector is in standby (projector off with power being
supplied).
Enable:
Power on enabled.
Disable*:
Power on disabled.
Important!
Performing an “Initialize Network Settings” operation or
“Restore All Defaults” operation with the setup menu will
cause this setting to change to “Disable”. If you are operating
the projector using a wired LAN setting, be sure to change
this setting back to “Enable” after initialization.
PJLink
authentication
RCVHDUN
Single Enables and disables PJLink connection authentication.
Enable*:
PJLink connection authentication enabled.
Disable:
PJLink connection authentication disabled.
Wired LAN info
RCVHDUN
Single Displays the following information.
Projector name:
Name currently assigned to the projector.
MAC Address:
Fixed MAC address assigned to each individual projector.
IP Address:
Projector’s current IP address.
DHCP:
Projector’s current DHCP setting status (“Auto” or “Disable”).
The projector name, IP address, and DHCP settings can be
configured using the projector System Admin page, which can be
accessed on a computer connected by LAN to the projector. For
details, see the “Wireless Function Guide” on the CD-ROM that
comes with the projector.
Initialize
Network
Settings
RCVHDUN
Single Returns all projector network settings (all settings on the System
Admin page) to their initial defaults.
For detailed information about System Admin page settings, see the
“System Admin Page Settings” section in the “Wireless Function
Guide” on the CD-ROM that comes with the projector.