Filter
Top Products
73
Modifying YP-100 Manual Connection Settings
The following are example cases in which you may want to modify YP-100 manual
connection settings.
• When you want to configure
YP-100 settings to be compatible with information configured
on the wireless LAN access point you are using
• When you want to enhance security by modifying initial default settings
• When you want to establish a wireless LAN connection using a fixed IP address
• When using another manufacturer’s wireless LAN adapter or a wireless LAN adapter built
into the computer
You can modify manual connection settings using Web Setup.
To modify YP-100 manual connection settings
Important!
Performing the procedure below to modify the connection profile being used for the
wireless LAN connection between the
YP-100 and computer will terminate the current
connection. To re-establish a connection, reconfigure the computer’s wireless LAN
settings so they match those of the new
YP-100 connection profile.
1
Perform the procedure under “To display and log into the Web Setup page”
(page 64) to display the Web Setup top page.
2
In the “Connection Profile Setup” area, click the [Edit] button.
z This will display a dialog box for configuring the connection profile.
3
Click a tab (Manual Connection 1, 2, or 3) to display the connection profile
whose settings you want to modify.
4
Configure the settings on the tab that is displayed.
z For details about each of the settings on the dialog box, see “Manual Connection Setting
Reference” (page 79).
5
To save your settings, click the [Save] button.
z This should cause the message “Your settings have been saved.” to appear.
z If there is anything wrong with the settings, the message “Some input items are missing.”
will appear. If this happens, click [Return] in the lower left corner of the page to return
to the connection profile setup page, and correct the settings as required. When checking
your settings, refer to “Manual Connection Setting Reference” (page 79).
Note
To use a modified connection profile for a wireless LAN connection, you will need to
switch to the profile (unless you modified the connection profile that you are currently
using). For details, see “To switch the YP-100 connection profile” (page 68).