Filter
Top Products
13
Cisco 10005 ESR AC Power Supply Installation
78-12652-01
FCC Class B Compliance
Troubleshooting the Installation
Table 1 contains troubleshooting tips for an AC-powered Cisco 10005 ESR.
FCC Class B Compliance
The equipment described in this manual generates and might radiate
radio-frequency energy. If it is not installed in accordance with Cisco installation
instructions, it might cause interference with radio and television reception. This
equipment has been tested and found to comply with the limits for a Class B
digital device in accordance with the specifications in part 15 of the FCC rules.
These specifications are designed to provide reasonable protection against such
interference in a residential installation. However, there is no guarantee that
interference will not occur in a particular installation.
Modifying the equipment without written authorization from Cisco might result
in the equipment no longer complying with FCC requirements for Class A or
Class B digital devices. In that event, your right to use the equipment might be
limited by FCC regulations, and you might be required to correct any interference
to radio or television communications at your own expense.
Table 1 Troubleshooting AC-Powered Systems
Symptom Steps to Take
System fails to power
on
Check that:
• All power cords are properly connected to the
Cisco 10005 and at the power connection end.
• The power switches are in the | (On) position.
• The Power LED is on (green).
• The fan assembly is fully inserted (Fan Status
LED is green).
Power supply Fault
LED is on (yellow)
• Make sure the power switch on the power module
is set to | (On).
• For more troubleshooting information, see the
Cisco 10000 Series ESR Troubleshooting Guide.