Filter
Top Products
5
Release Note for the Cisco 11000 Series Secure Content Accelerator: SCA/SCA2
78-14640-03
Operational Notes
•
When writing a configuration via the GUI, the existing configuration is erased first; therefore, all
configurations written using the GUI should be complete configurations. Incremental configuration
updates are only possible by adding the changes to a complete configuration, and then writing this
configuration. An option for overwriting or incrementally updating a configuration using a written
configuration will be added at a future date.
• The GUI caches certain items and can misrepresent the state of the actual device in certain
circumstances, such as if the device is rebooted without saving changes. To obtain the current device
state, refresh the page. This can be accomplished by holding the SHIFT-clicking the Refresh button.
• Once Web management is enabled, it is always accessible via the “Server” port (two-port mode) or
the “Network” port (one-port mode) even if SSL client-side access has been configured. Use an
access list to prevent unwanted access.
• Assigning a Web management access list to the device completely prevents HTTPS access from the
GUI. Setting the following access list allows HTTPS access to the GUI from any IP address:
access-list 10 permit 127.0.0.1 0.0.0.0
web-mgmt access-list 10
CLI Notes
• The copy to startup-configuration command replaces the public startup-configuration. The keys
and passwords still exist unless they have been deleted or erased.
• Erasing the running-configuration of a device using the CLI disconnects any GUI or telnet sessions
from the device. To continue configuration, reconnect to the device.
• The custom completer completes previously created objects with the word “create” if TAB is
pressed after the full name is typed. To edit an existing object, ensure “create” is not part of the
command.
• When writing configuration files to the running configuration, the new configuration file appends to
the existing configuration rather than replacing it. In the process of recreating existing configuration
information, some errors will be displayed. These can be ignored safely.
SNMP Notes
The factory-set default SNMP community is “public”; however, “public” is not listed in the configuration.
The behavior of setting and resetting the SNMP community is demonstrated in the table below.
Command SNMP community is set to...
SNMP community in
configuration is...
snmp default community XYZ XYZ XYZ
no snmp default community XYZ No default community listed
snmp default community
public
public public