Filter
Top Products
3
Connect the Hub to Other Network Devices
(continued)
DOWN
UP
5x
MDI -X
MDI
LED
ON
OFF
SPEED
100BaseTX
10BaseTX
RATING
100-127 /200-240 V~
0.3A / 0.2 50/60 Hz
1
6x
7x
8x
1x
Cisco 1538M
2x
3x
10/100
4x
CONSOLE
23
4
5
678
RJ-45-to-RJ-45
rollover console cable
(supplied)
RJ-45-to-DB-9
adapter (supplied)
Console port
(RJ-45)
P
ower outlet
Connect the Console Cable
1
Make sure console port settings of the
hub match the settings of the terminal,
PC, or laptop. The default settings of
the hub console port are 9600 baud,
8 data bits, 1 stop bit, no parity, and
no flow control.
2
Connect the rollover console cable to
the CONSOLE port on the hub.
3
Connect the other end of the rollover
cable to your terminal, PC, or laptop
(if necessary, use an appropriate
adapter, such as the supplied
RJ-45-to-DB-9 adapter).
4
From your terminal, PC, or laptop, start
the terminal emulation program.
Power Up the Hub
1
Connect one end of the power cord to
the hub and the other end to a power
source.
2
Wait approximately 2 minutes for the
hub to complete its power-on self-test
(POST).
After POST completes, the Continue
with configuration dialog? prompt
appears on the management station.
You can then follow the prompts to
assign IP information to the hub.