Filter
Top Products
5
6 Connect a PC to the Router (Optional)
This step is optional, and required only if you want to use the Cisco IOS CLI to configure or troubleshoot the router, instead of
SDM. To use Cisco IOS software to configure the router, it must be connected to a terminal or to a PC with terminal-emulation
software. Terminal emulation software should be configured with the following settings: 9600 baud, 8 data bits, no parity bits,
and 1 stop bit. The Cisco 1710 Security Router Software Configuration Guide describes how to configure the router using Cisco
IOS software.
Follow these steps to connect the router to a terminal or PC:
Step 1 Connect the RJ-45 end of the console cable (included) to the CONSOLE port on the back panel of the router.
Figure 2 Connecting a PC to the Router
Step 2 Connect the DB-9 end of the console cable to the console port (also called the serial port) on your PC. If this adapter
does not fit your PC console port, you must provide an adapter that fits.
56530
Cisco 1710
CONSOLE
AUX
FDX
100
LINK
LNK
LINK
FDX
MOD OK
Console port
Console cable
To PC or terminal
10/100 ETHERNET
10BT ETHERNET