2 Release Notes for Cisco Network Registrar 3.0(1)T
Introduction
Introduction
The release of Network Registrar 3.0(1)T contains the following components:
• CD-ROM containing the software
• Network Registrar Concepts Guide
• Getting Started with Network Registrar
• Network Registrar CLI Reference Guide
• Network Registrar User’s Guide
• Cisco Network Registrar 3.0 AIX Installation
• Cisco Network Registrar 3.0 HP-UX Installation
• Network Registrar Web GUI Installation Instructions
• Release Notes for Network Registrar 3.0(1)T
Network Registrar includes Windows
NT servers, CLI, and GUI, and Solaris
servers, CLI, and a
Motif
GUI, and AIX
and HP-UX
servers and CLI.
You can run the servers and the associated user interfaces on the appropriate platform, or you can
run the servers on one platform and the user interfaces on another.
System Requirements
Network Registrar 3.0(1)T runs on Windows NT 4.0, Solaris 2.5.1, and Solaris 2.6. Network
Registrar’s 3.0(1)T GUI also runs on Windows 95.
For all OS platforms, Cisco recommends that you install the current service pack (Windows) or
recommended patch cluster (Solaris).
• Windows NT 4.0 must be run with service pack 3, or for Y2K compliance, on service pack 4.
• Solaris 2.5.1 has been tested with the recommended patch cluster that was current on February
11, 1998. In particular, it was tested with these patches installed:
Table 1 Solaris 2.5.1 Patches
103461-20 103558-11 103566-25
103582-15 103594-13 103603-06
103612-38 103622-09 103630-09
103640-17 103663-09 103680-01
103686-02 103690-05 103696-03
103738-05 103743-01 103817-02
103866-05 103879-04 103900-01
103901-08 103934-06 103959-06
104010-01 104166-03 104212-09
104246-05 104266-01 104283-03
104317-01 104331-04 104334-01
104338-02 104433-06 104516-03
104533-03 104613-01 104650-02
104654-03 104692-01 104708-09