Cisco Systems 3020 Switch User Manual


 
14
Step 9 Enter the IP address 10.0.0.1 and press Enter.
The Express Setup home page appears.
Step 10 Go to “Completing the Express Setup Fields” section on page 17 to finish setting up the switch
module using the Express Setup screen of the Device Manager.
Using the Onboard Administrator to Assign an IP Address to the
Switch Module fa0 Interface
For the switch module to obtain an IP address for the fa0 interface through the Onboard
Administrator, these conditions must be met:
The blade server is powered on and connected to the network.
Basic configuration of the Onboard Administrator is completed, and you have the username and
password for the Onboard Administrator.
A DHCP server is configured on the network segment to which the blade server is connected,
or the Onboard Administrator is configured to run as a DHCP server.
Note See the Onboard Administrator user guide at
http://www.hp.com/go/bladesystem/documentation for more information about configuring
and using the Onboard Administrator.