Filter
Top Products
78-5296-02 10/02/98 Hardware Description 1
Cisco 6200 User Guide 1-19
The MPC runs a version of Cisco IOS software that is designed for DSL multiplexing.
At startup, the MPC loads program software and configuration data from NVRAM, from a server on
the network, or from a Flash card in one of its PCMCIA slots. The MPC then provides boot images
to the line cards. After initializing the system, the MPC provides monitoring and control services,
including the CLI (available at the console and via Telnet); SNMP communication with the Cisco
6200 Manager; and critical, major, and minor alarm signals.
1.4.2 Physical Description
The MPC resides in slot 2. The MPC faceplate (see Figure 1-9) includes the fixtures discussed in the
following paragraphs.
Figure 1-9 MPC Faceplate
ACO Switch
The alarm cut-off (ACO) switch is a pushbutton located near the top of the MPC. Press the switch
to turn off an audible alarm. (For more information on alarms, see the “Alarm Relay Connection”
section on page 1-5.)
11948
Card status LEDs
Alarm cut-off switch
Alarm LEDs
Console port
Two PCMCIA slots
PCMCIA ejection buttons
Ethernet port
Reset switch
ACO
POWER
MPC
READY
ACTIVE
CRIT
MAJ
MIN
ALARMS
0 1
ACTV
LINK
SLOT
E
N
E
T
C
N
S
L