Cisco Systems 69561 Network Router User Manual


 
mobility group. You can configure up to 12 Wireless Services Module (WiSM) blades in one
mobility group. Therefore, up to a maximum of 3600 access points (APs) are supported in a
single mobility group.
Q. How does DHCP work with the WLC?
A. The WLC acts as a DHCP relay device. The WLC does the DHCP relay through the
virtual interface. Typically, the 1.1.1.1 address is assigned to the virtual interface. This
address can be any address. However, it must not be a routable address.
These are the events that occur:
The WLAN client sees the administration−defined virtual address as the DHCP
server address. The recommended address is usually 1.1.1.1 because this address is
not normally a routable network address.
1.
The WLC shows the virtual address to the WLAN clients and the management
interface address upstream.
2.
The WLC acts as a DHCP relay (Bootstrap Protocol [BOOTP] relay) device.3.
Note: When the internal DHCP server is used, the lightweight access point (AP) should be
directly connected to the WLC. Also, you cannot share a DHCP scope between two or more
WLCs.
Q. Does the Cisco 4400 Series WLC support Internetwork Packet
Exchange (IPX) protocol? Does any Airespace product support IPX
protocol?
A. No, IPX protocol is not supported on any platforms of the Cisco WLC.
Q. What are the prerequisites to access the graphical user interface
(GUI) of the Wireless LAN Controller (WLC)?
A. The controller GUI requires this operating system and web browser:
Windows XP Service Pack 1 (SP1) or later, or Windows 2000 SP4 or later
Internet Explorer 6.0 SP1 or later
Note: Internet Explorer 6.0 SP1 or later is the only browser supported to access the
controller GUI and to use WebAuth.
Q. Is the Wireless LAN Controller (WLC) GUI supported on Mozilla
browsers?
A. No, WLC GUI is not supported on Mozilla browsers.
Q. How do I retrieve Cisco Wireless LAN Controller (WLC) MIBs on the
web?
A. You can download the Cisco WLC MIBs from the Wireless Downloads (
registered customers
only
) page.
Complete these steps in order to download the WLC MIBs: