Filter
Top Products
3-5
Cisco ONS 15530 Configuration Guide and Command Reference
78-16019-02, Cisco IOS Release 12.2(18)SV2
Chapter 3 Initial Configuration
Configuring IP Access on the NME Interface
The Cisco ONS 15530 NME interface should now be operating correctly.
Note If a CPU switch module switchover occurs, you can use the same IP address to access the redundant
CPU switch module after it becomes active.
Note In a multiple shelf node configuration, perform these steps on the NME interfaces on all shelves in
the node.
Displaying the NME Interface Configuration
To display the configuration of the NME interface, use the following EXEC command:
Step 10
Switch(config-if)# duplex {auto | full | half} Specifies the duplex mode. The default is auto
(autonegotiation).
Step 11
Switch(config-if)# no shutdown Enables the interface.
Step 12
Switch(config-if)# exit
Switch(config)#
Returns to global configuration mode.
Step 13
Switch(config)# line vty line-number
Switch(config-line)#
Enters line configuration mode for virtual terminal
connections. Commands entered in this mode control
the operation of Telnet sessions.
Step 14
Switch(config-line)# password password Specifies a password for Telnet sessions.
Step 15
Switch(config-line)# end
Switch#
Returns to privileged EXEC mode.
Step 16
Switch# copy system:running-config
nvram:startup-config
Saves the configuration changes to NVRAM.
Command Purpose
Command Purpose
show interfaces fastethernet 0 Displays the NTP status.