Filter
Top Products
FINAL DRAFT —Cisco Confidential
2-6
Cisco ASR 9000 Series Aggregation Services Router Getting Started Guide
OL-17502-01
Chapter 2 Bringing Up Cisco IOS XR Software on the Router
Verifying the System After Initial Boot
Configuration register on node 0/RSP0/CPU0 is 0x2
Boot device on node 0/RSP0/CPU0 is disk0:
--More--
show platform Command: Example
The show platform command displays information on router resources. In EXEC mode, the show
platform command displays the resources assigned to the RP you are managing. In administration
EXEC mode, the show platform command displays all router resources.
RP/0/RSP0/CPU0:router# show platform
Node Type State Config State
-----------------------------------------------------------------------------
0/RSP0/CPU0 A9K-RSP-4G-HDD(Active) IOS XR RUN PWR,NSHUT,MON
0/1/CPU0 A9K-40GE-B IOS XR RUN PWR,NSHUT,MON
0/4/CPU0 A9K-8T/4-B IOS XR RUN PWR,NSHUT,MON
0/6/CPU0 A9K-4T-B IOS XR RUN PWR,NSHUT,MON
The following administration EXEC mode example shows all router nodes:
RP/0/RSP0/CPU0:router# admin
RP/0/RSP0/CPU0:router(admin)# show platform
Node Type State Config State
-----------------------------------------------------------------------------
0/RSP0/CPU0 A9K-RSP-4G-HDD(Active) IOS XR RUN PWR,NSHUT,MON
0/FT0/SP FAN TRAY READY
0/FT1/SP FAN TRAY READY
0/1/CPU0 A9K-40GE-B IOS XR RUN PWR,NSHUT,MON
0/4/CPU0 A9K-8T/4-B IOS XR RUN PWR,NSHUT,MON
0/6/CPU0 A9K-4T-B IOS XR RUN PWR,NSHUT,MON
0/PM0/SP A9K-3KW-AC READY PWR,NSHUT,MON
0/PM1/SP A9K-3KW-AC READY PWR,NSHUT,MON
0/PM2/SP A9K-3KW-AC READY PWR,NSHUT,MON
The following example shows information for a single node in the router:
RP/0/RSP0/CPU0:router# show platform 0/1/CPU0
Node Type State Config State
-----------------------------------------------------------------------------
0/1/CPU0 A9K-40GE-B IOS XR RUN PWR,NSHUT,MON
For more information on node IDs, see Cisco IOS XR System Management Configuration Guide.
For more information on the show platform command, see Cisco IOS XR Interface and Hardware
Component Command Reference.
show redundancy Command: Example
To view information about the active and standby (inactive) RPs, type the show redundancy command
as follows: