2-3
Cisco Aironet 1550 Series Outdoor Mesh Access Point Hardware Installation Guide
OL-24247-01
Chapter 2 Installing the Access Point
Tools and Hardware
–
4-ft (1.2-m) streetlight power tap adapter (AIR-PWR-ST-LT-R3P=) for light pole installations
in the US and Canada
• Antennas, 2.4/5-GHz (refer to the “Antenna Configurations” section on page 1-13)
• Optional battery backup unit (AIR-1520-BATT-6AH=)—Used only on models 1552E and 1552EU
• FIPS kit (AIRLAP-FIPSKIT=)
• 1000BASELX single-mode Rugged SFP (GLC-LX-SM-RGD=)
• 1000BASESX multimode Rugged SFP (GLC-SX-MM-RGD=)
• EPON ONU Rugged SFP module
• Optional pole mount kit (AIR-ACCPMK1550=)
• Optional strand mount kit (AIR-ACCSMK1550=)
• Optional banding strap tool (BAND IT) (AIR-BAND-INST-TL=)
• Optional directional-antenna mounting kit (AIR-ACCAMK-1)
• Lightning Arrestor kit (CGR-LA-NM-NF)
• Third-party lightning arrestors as required by local authorities
Optional Tools and Hardware That You Supply
Tools and materials that are user-supplied are:
• Ground lug crimping tool (Panduit CT-720 with CD-720-1 die)
• 6-AWG copper ground wire
• 13 mm box-end wrench or socket set
• Adjustable wrench, 22 mm socket, or Sealcon S-2200-WR socket wrench
• #8 Torx screwdriver
• Small flat screwdriver for DC power connector
• Optional shielded outdoor-rated Ethernet (CAT5e or better) cable with 0.20 to 0.35 in
(0.51 to 0.89 cm) diameter
• Optional Ethernet RJ-45 connector and installation tool
• Optional shielded outdoor-rated DC power cable with 0.20 to 0.35 inch (.0.51 to 0.89 cm) diameter
• Optional cable F-connector adapter (stinger)
• Optional ground rod, as required by local regulations
• Optional ladder, power lift, rope, or other tools as required
Pole Installation Hardware and Tools
To install the access point on a vertical or horizontal metal, wood, or fiberglass pole, you need the
following additional hardware and tools:
• Pole mount kit (AIR-ACCPMK1550=)
–
Pole clamp bracket
–
Two gusset strap brackets