Filter
Top Products
52-10
Cisco ASA 5500 Series Configuration Guide using ASDM
Chapter 52 Configuring the Cisco Phone Proxy
Prerequisites for the Phone Proxy
Cisco IP Communicator Prerequisites
To configure Cisco IP Communicator (CIPC) with the phone proxy, you must meet the following
prerequisites:
• Go to Configuration > Firewall > Unified Communications > Phone Proxy and select the “Enable
CICP security mode authentication” check box under the Call Manager and Phone Settings area.
• Create an ACL to allow CIPC to register with the Cisco UCM in nonsecure mode.
• Configure null-sha1 as one of the SSL encryption ciphers.
Current versions of Cisco IP Communicator (CIPC) support authenticated mode and perform TLS
signaling but not voice encryption.
Because CIPC requires an LSC to perform the TLS handshake, CIPC needs to register with the Cisco
UCM in nonsecure mode using cleartext signaling. To allow the CIPC to register, create an ACL that
allows the CIPC to connect to the Cisco UCM on the nonsecure SIP/SCCP signalling ports (5060/2000).
Note You can configure LSC provisioning for additional end-user authentication. See the Cisco Unified
Communications Manager configuration guide for information.
CIPC uses a different cipher when doing the TLS handshake and requires the null-sha1 cipher and SSL
encryption be configured. To add the null-shal cipher, use the show run all ssl command to see the output
for the ssl encryption command and add null-shal to the end of the SSL encryption list.
Note When used with CIPC, the phone proxy does not support end-users resetting their device name in CIPC
(Preferences > Network tab > Use this Device Name field) or Administrators resetting the device name
in Cisco Unified CM Administration console (Device menu > Phone Configuration > Device Name
field). To function with the phone proxy, the CIPC configuration file must be in the format:
SEP<mac_address>.cnf.xml. If the device name does not follow this format (SEP<mac_address>), CIPC
cannot retrieve its configuration file from Cisco UMC via the phone proxy and CIPC will not function.
Prerequisites for Rate Limiting TFTP Requests
In a remote access scenario, we recommend that you configure rate limiting of TFTP requests because
any IP phone connecting through the Internet is allowed to send TFTP requests to the TFTP server.
To configure rate limiting of TFTP requests, configure the police command in the Modular Policy
Framework. See the command reference for information about using the police command.
Policing is a way of ensuring that no traffic exceeds the maximum rate (in bits/second) that you
configure, thus ensuring that no one traffic flow can take over the entire resource. When traffic exceeds
the maximum rate, the ASA drops the excess traffic. Policing also sets the largest single burst of traffic
allowed.
Rate Limiting Configuration Example
The following example describes how you configure rate limiting for TFTP requests by using the police
command and the Modular Policy Framework.
Begin by determining the conformance rate that is required for the phone proxy. To determine the
conformance rate, use the following formula: