Filter
Top Products
3-3
Cisco AVS 3120 Application Velocity System Hardware Installation Guide
OL-11805-01
Chapter 3 Installing the AVS 3120
Installing Your AVS 3120
This section contains the following procedures:
• Attaching a Two-Post Rack Bracket to the AVS 3120
• Installing the AVS 3120 on a Workbench or Tabletop
Attaching a Two-Post Rack Bracket to the AVS 3120
You may install the AVS 3120 in either a four-post rack or a two-post rack by using the two-post rack
brackets included in the accessory kit. Follow these steps:
1. Place the right-hand bracket on the right side of the AVS 3120, as shown in Figure 3-1. Align the
bracket with the screw holes in the AVS 3120, and use two round head screws to secure the bracket.
Repeat this step to attach the left-hand bracket to the AVS 3120. Note that the brackets are different.
Warning
To prevent bodily injury when mounting or servicing this unit in a rack, you must take special
precautions to ensure that the system remains stable. The following guidelines are provided to
ensure your safety:
• This unit should be mounted at the bottom of the rack if it is the only unit in the rack.
• When mounting this unit in a partially filled rack, load the rack from the bottom to the top with the heaviest
component at the bottom of the rack.
• If the rack is provided with stabilizing devices, install the stabilizers before mounting or servicing the unit in
the rack.
Statement 1006