Filter
Top Products
2
1 About this Guide
This guide provides instructions on how to use Express Setup to initially configure your Catalyst switch. Also covered are switch
management options, basic rack-mounting, stacking guidelines, port and module connection procedures, and troubleshooting
help.
For additional installation and configuration information for the switch, see the Catalyst 2975 documentation on Cisco.com.
For system requirements, important notes, limitations, open and resolved bugs, and last-minute documentation updates, see the
release notes, also on Cisco.com. For translations of the warnings that appear in this publication, see the Regulatory Compliance
and Safety Information for the Catalyst 2975 Switch on the documentation CD. The product warranty information is also
included on the documentation CD.
When using the online publications, refer to the documents that match the Cisco IOS software version running on the switch.
The software version is on the Cisco IOS label on the switch rear panel.
2 Unpacking the Switch
Follow these steps:
1. Unpack and remove the switch and the accessory kit from the shipping box.
2. Return the packing material to the shipping container, and save it for future use.
3. Verify that you have received the items shown below. If any item is missing or damaged, contact your Cisco representative
or reseller for instructions.
1
Catalyst 2975 switch
7
Four rubber mounting feet
2
Documentation
8
Six number-8 Phillips flat-head screws
3
AC power cord
9
Four number-12 Phillips machine screws
4
Console cable
10
One black Phillips machine screw
5
Two 19-inch mounting brackets
11
Connector cover for redundant power system; two number-4 pan head screws
6
Cable guide
1
3 4
5
6 7
8 9
10
11
205076
Cisco Product
Documentation
CD
2
Catalyst 2975G
Se
ries
P
oE-48