Filter
Top Products
IPmux-1/1E Installation and Operation Manual Appendix E Configuration Menus
IPmux-1E Configuration E-23
Table E-13. T1 Configuration Parameters (Cont.)
Parameter Possible Values Remarks
Cond. CAS first 2.5
sec Pattern
0 to F (ESF)
0 to 3 (D4)
FF
2 or 4 Bit Code applied (during the first 2.5 seconds) to
AB(D4) or ABCD (ESF) bits (relevant in CAS mode only)
when fault conditions occur. After the first 2.5 seconds
the code specified in ‘Cond. CAS (ABCD) pattern’ is
applied. ABCD conditioning pattern can be applied
toward the IP path when loss of signal, loss of frame or
AIS detected at the T1 line. Conditioning pattern can
also be applied toward the T1 line when packet receive
buffer overrun or underrun occurs. When configuring
FF to this function, this parameter is ignored and the
CAS pattern applied in the first 2.5 seconds is the same
as defined in ‘ Cond. CAS (ABCD) pattern’.
Note: This field does not appear if “Unframed” is
selected in the Line Type field or if CAS Disable is
selected.
Default: FF
E.5 IPmux-1E Configuration
IPmux-1E automatically detects whether the interface is ISDN or Analog, and the
appropriate menu appears (see Figure E-26 and Figure E-28).
ISDN Configuration
ISDN CONFIGURATION
1. Interfaces Mode Terminal
2. Transmit Clock Source Adaptive
3. Channel Configuration >
ESC. Exit
Select item from the menu.
Figure E-26. ISDN Configuration Menu
Main Menu
↓
2. Configuration (ISDN)
↓
2. ISDN Configuration