Filter
Top Products
Send documentation comments to nexus5kdocs@cisco.com.
2-13
Cisco Nexus 6000 Series Hardware Installation Guide
OL-15902-01
Chapter 2 Installing the Cisco Nexus 6000 Series Switches
Starting the Switch
Note Do not connect the Ethernet port to the LAN until the initial switch configuration has been performed.
For instructions on configuring the switch, see the Cisco Nexus 6000 Series CLI Configuration Guide.
For instructions on connecting to the console port, see the “Connecting to the Console Port” section on
page 3-2.
Warning
When installing or replacing the unit, the ground connection must always be made first and
disconnected last.
Statement 1046
To power up the switch and verify hardware operation, follow these steps:
Step 1 Verify that empty power supply slots have filler panels installed, the faceplates of all modules are flush
with the front of the chassis, and the captive screws of the power supplies, fan module, and all expansion
modules are tight.
Step 2 Verify that the power supply and the fan modules are installed.
Note Depending on the outlet receptacle on your power distribution unit, you may need the optional
jumper power cord to connect the switch to your outlet receptacle. See the “Jumper Power Cord”
section on page C-8.
Step 3 Ensure that the switch is adequately grounded as described in the “Grounding the Switch” section on
page 2-7, and that the power cables are connected to outlets that have the required AC power voltages
(see the “Power Specifications” section on page B-2).
Step 4 For the switch, insert each end of the power clip (from the accessory kit) into holes on tabs located on
either side of the power connectors (see Figure 2-16).
Step 5 Connect each power cable to the power connectors on the chassis and an AC power source. Press the
power cable into the power clip to endure that the power cable stays connected to the chassis when
bumped. The switch should power on as soon as you connect the power cable.
Step 6 Listen for the fans; they should begin operating when the power cable is plugged in.
Step 7 After the switch boots, verify that the LED operation is as follows:
• Fan module—Status LED is green.
• Power supply—Status LED is green.
• After initialization, the system status LED is green, indicating that all chassis environmental
monitors are reporting that the system is operational. If this LED is orange or red, then one or more
environmental monitor is reporting a problem.
• The Link LEDs for the Ethernet connector should not be on unless the cable is connected.
Note The link LEDs for the Fibre Channel ports remain yellow until the ports are enabled, and the
LED for the Ethernet connector port remains off until the port is connected.
Step 8 Try removing and reinstalling a component that is not operating correctly. If it still does not operate
correctly, contact your customer service representative for a replacement.