Filter
Top Products
6-4
Cisco WAN Access Performance Management System User Guide, 2.1
OL-5512-01
Chapter 6 Adding Cisco IOS Routers to Cisco WAPMS
Adding Routers in Network Configuration
Figure 6-3 ASE Configuration Window
Step 8 In the ASE Configuration window for ATM routers, click ATM to verify the WAN link layer parameters
for the router (this option is not available for Frame Relay).
The ATM Link Layer Configuration window appears, as shown in Figure 6-4.
Figure 6-4 ATM Link Layer Configuration Window
For ATM read-only settings, see Table 6-1.
Step 9 Once you have verified the ATM link layer settings, click Close.
Step 10 Click Close in the ASE Configuration window.
Step 11 Click OK in the Add/Edit an Access Line window to apply the settings.
Table 6-1 ATM Link Layer Settings for Cisco Routers
Option Description
Scramble Configuration Indicates whether payload data is scrambled at transmission and
unscrambled when received. Displayed values are Enabled or
Disabled. This parameter is set at the device during installation.
Framing Method of cell synchronization. Displayed values are HEC (header
error control) or PLCP (physical layer convergence protocol). This
parameter is set at the device during installation.