Filter
Top Products
Chapter 5 Network Element Management
Network Element Management Window
5-10
Cisco Catalyst Switch Manager User Guide
OL-6380-01
SNMP Trap Tab
The following areas are available on the Configuration tab of the Network
Element Management window:
• Trap Generation
• SNMP Trap
Trap Generation
The Trap Generation area provides:
• SNMP Trap Status—Indicates the level at which SNMP traps are enabled.
The level is one of these values:
–
disabled
–
layer2Only—SNMP traps are enabled on the datalink layer only.
–
layer3Only—SNMP traps are enabled on the network layer only.
–
layer2And3—SNMP traps are enabled on the datalink and network
layers.
• Enable—Enables all SNMP trap generation from the switch or router.
• Disable—Disables all SNMP trap generation from the switch or router.
SNMP Trap
The SNMP Trap area provides:
• Trap Client IP Table—IP address table to which SNMP traps generated by the
switch or router are sent.
–
Trap Client IP—IP address to which SNMP traps are sent.
–
Client Community—Community string used within the SNMP trap.
–
SNMP Version—Version of the SNMP protocol used by Cisco EMF to
communicate with the managed device. This field has the following
value: snmpv2c.
–
Notification Layer - Indicates the level at which the SNMP trap client is
defined. The level is one of these values: