Filter
Top Products
9
Release Notes for Cisco ONS 15600 Release 8.0
OL-10906-01
Resolved Caveats for Release 8.0
TL1
CSCsd52415
You cannot set the GIGE admin state to IS,AINS using the TL1 ED-GIGE command for the ONS 15600
ASAP card. The TL1 ED-GIGE command denies attempts to change the ADMIN state to IS,AINS this
card. CTC, however, can execute the state change. This issue is resolved in Release 8.0.
CSCsd95331
The status field incorrectly displays IS-NR when performing a RTRV-EQPT TL1 command where the
AID is of type PIM (Pluggable I/O Module) or PPM (Pluggable Port Module). Since PIMs and PPMs do
not support equipment protection, the status field should display NA. This issue is resolved in Release
8.0.
CSCsg77314
Standby TSC deletes DB without a sync from Active TSC causing an outage on the default DB. If the
Standby shelf controller reboots, by design it deletes its DB and syncs. If It cannot sync, it creates a
default DB. If it is called upon to be the active shelf controller, traffic is dropped. This issue has been
resolved in this release and in future releases.
CSCse40756
For multiple downloads, DNLD status is only updated for one node on network view.
When downloading six 600 nodes at the same time, the download status field on CTC was updated
properly on just one of the six 600 nodes. The workaround is to check-in the individual status of the
download on each node. This issue is resolved in Release 8.0.
CSCsf01341
Some circuits might be displayed as PARTIAL after one or more ONS 15600SDH nodes is upgraded to
Release 8.0 from Release 1.40. This can occur when the ONS 15600SDH has circuits with their drops
on the ONS 15600SDH nodes. The workaround is to run "Circuit Reconfigure" on the affected PARTIAL
circuits. This issue is resolved in Release 8.0.