Filter
Top Products
2 Cisco UC320W Quick Start Guide
Welcome
Thank you for choosing the Cisco Small Business Unified Communications
Model UC320W. This guide describes how to install the equipment and
get started configuring the system.
Before You Begin
Minimum Requirements
• Computer with web browser. Cisco recommends Internet Explorer
version 7 or later or Firefox version 3.6 or later.
• Adobe Flash Player version 10.1 or later.
• Cisco SPA300 Series or Cisco SPA500 Series IP phones.
• Power adapters for the phones, as needed. Cisco SPA300 Series
phones always require power adapters. Cisco SPA500 Series phones
can receive power from a Power over Ethernet switch.
• Ethernet cables to connect IP phones and computers.
• Internet service.
• Voice over IP service or analog phone service.
• Optional: 2GB+ USB Flash key (FAT32 format) for site backups.
Default Settings
NOTE To restore these default settings at any time: Using a paperclip or
similar object, press and hold the Reset button on the side panel for 10
seconds.
CAUTION Before installing the Cisco UC320W into an existing network
with another DHCP server, refer to the Smart Designs (see links on
page 4). IP address conflicts will result if two DHCP servers are installed
on your network.
Parameter Default Value
Username cisco
Password cisco
LAN IP
(Also the address for the web-based
configuration utility.)
192.168.10.1
DHCP Range
(DHCP server is enabled by default.)
192.168.10.100 to 149
Netmask 255.255.255.0
Voice VLAN 100
Default Voice VLAN Subnet 10.1.1.1
1