— 72 —
GS V m ......... (1)
GS V m n ..... (2)
[Function] Cutting the paper
[Code] (1) <1D>H<56>H<m>
(2) <1D>H<56>H<m><n>
[Range] (1) m = 0, 1, 48, 49
(2) m = 65, 66
0
n 255
[Outline] Performs the specified paper cutting.
m Function
0,1,48,49 Paper cut (full cut) (Leaving a bridge area uncut)
65,66
Paper feed by “cut position + {n × basic calculation
pitch}”and paper cut (full cut) (Leaving a bridge area uncut)
[Caution] • Fully cut for the label sheet specs.
• In STANDARD MODE, this command only works when it is
entered at the beginning of a line.
For (1):
• A partial cut (Leaving a bridge area uncut) is executed.
For (2):
• If n = 0, the paper is fed to the cut position, and then cut. If n
≠ 0, the paper is fed by “n × basic calculation pitch” inches
past the cut position, and then cut.
• The basic calculation pitch is set by GS P.
The paper feed amount is calculated with the vertical basic
calculation pitch (y).
A fraction resulting from the calculation is corrected with the
minimum pitch of the mechanism, and the remainder is
omitted.