Filter
Top Products
CNet Technology Inc.
http://www.cnet.com.tw
USB Modem Does Not Work With the Router
admin admin.
If your USB modem is not working with the router. Check the support list to ensure you are using a supported device.
CNet’s supported device list changes regularly. We update our supported device list after a device is approved. If the
device you have is not on the list, that means we do not support it at this time. The supported device list can be found
at: http://www.cnet.com.tw
If you are still unable to access the Internet after following above instructions. Please consult the User Manual or
contact CNet Technical Support for further assistance.
The factory default settings will be restored and the router’s IP address will be reset to 192.168.1.1, user name to
, and password to
How to Restore the Default Password and Configuration Settings
1. Use a sharp object such as a pen or a paper clip to press and hold the Reset button, located on the rear panel of
the router next to the power jack, for about 10 seconds, until the STATUS light goes off.
2. Release the Reset button, and wait for the router to restart, and for the Power light to stop blinking and become
solid green.
How to Set up Broadband Internet Service & Other Functions
In the User Manual on product CD, You can find detail steps of:
Setting up Broadband Internet Service such as 3G, Cable modem, WiFi ISP
Advanced settings such as DDNS, Virtual Server, DMZ
For additional information, please visit the product website: http://www.cnet.com.tw
Through xDSL Modem - PPPoE
Click on from the left
navigation pane.
Connect one end of the Ethernet cable to
the WAN port of CBR-980, and another end
to the Ethernet port of xDSL modem.
Select in
drop-down menu and in
drop-down menu. Fill in the
user name and password provided by your
xDSL service provider. Click button
to finish setup process. The router will be
restarted shortly. Once the
shows up, you are ready to surf the Internet!
One Button Setup
WAN interface
WAN
Access Type
Finsih
Ethernet Port
PPPoE
login page
Connect to the Internet through xDSL Modem
Technical Information
LED Status Lights
WIRELESS/WPS
LAN
Signifies that the WiFi radio of the
router is “On”. Blinking indicates traffic.
Signifies that connection is made on LAN port.
Blinking indicates traffic.
Power
Status
WAN
Signifies the router has power
Blinking Green light indicates Reset or Firmware
updates is in progress.
Blinking Orange
light indicates the router goes into “WiFi Protected Setup”
mode.
Signifies that connection is made on WAN port.
Blinking indicates traffic
WIRELESS/WPS
Power
LAN
WAN
Status
WPS button