Filter
Top Products
Setting Dynamike
This controls the microphone sensitivity
(outgoing audio level).
To Transmit
21
To Transmit
Setting
Dynamike
20
Transmit
RF Meter
Caution!
Be sure the antenna is properly
connected to the radio before
transmitting.Prolonged trans-
mitting without an antenna,or
a poorly matched antenna,
could cause damage to the
transmitter.
Be sure to read the F.C.C.Rules
and Regulations included with
this unit before transmitting.
Operation Operation
1
Select desired channel.
1
1
Initially,set fully clockwise so that maxi-
mum voice volume is available.Dynamike
may have to be reduced in some conditions.
Transmit
Press and hold mic button to transmit.
Transmitter is now activated.When transmit-
ting,hold the microphone two inches from
your mouth and speak in a clear,normal voice.
Release to receive.
1
The S/RF-SWR-CAL switch must be in the
S/RF position.
RF Meter
This meter swings proportionately to the RF
output (outgoing signal) while transmitting.
148 NW ST manual 3.3 6/15/99 3:12 PM Page 20