Filter
Top Products
Chapter 4: Using the Printer36
A760 Two-Color Thermal/Impact Hybrid Printer: User Guide 189-9200303 Rev. D A760-D100 10/04
Enable or disable check flip test mode
The check flip test verifies that the check flip mechanism will flip an inserted check only. It
does not read the check. Check flip test is enabled or disabled by selecting the “Diagnostic
Modes” sub-menu of the configuration menu. See “Configuring the printer”, page 32 for
instructions on how to enter the configuration menu.
Extended
slip table
DO NOT WRITE, STAMP OR SIGN BELOW THIS LINE
FE
DE
RAL R
ESER
VE
B
O
A
R
D O
F G
O
VER
N
O
R
'S RE
G
. CC
R
ESE
R
V
E
D FO
R FIN
AN
C
IAL IN
STITUTIO
N
U
SE
Slip
table
Check
guide
Green
slip-in LED
Check orientation - face down
Do not fold check
ENDORSE HERE
MEMO
Paper feed
button
To run the check flip test mode:
1 Enable the check flip test mode.
2 Exit the configuration menu.
3 Insert a check, lengthwise and face down into the
slip station as if validating. (See “Verifying and
validating checks,” page 28.)
Note: You must use a check to conduct the test. The test
will not run if a slip or form is inserted.
4 Push paper feed button.
The check is flipped and returned, but no printing is
performed.
To exit the check flip test mode:
1 Enter the configuration menu and “Diagnostic
Modes”
sub-menu again. (See page 32.)
2 Disable the Check flip test mode.
3 Exit the configuration menu.
The printer is on-line and can again normally
communicate with the host computer.