Filter
Top Products
7. Connect the display cable and the backlight cable to the inverter board
(Section 3.21).
8. Replace the inverter board (Section 3.21).
9. Replace the bezel (Section 3.21).
10. Connect the display ground cable [1] to the LIF clip above the serial
port connector (Figure 3-99).
11. Carefully insert the end of the display ground cable into the ZIF
connector slide on the system board (Figure 3-99).
IMPORTANT: Ensure that the ZIF connector slide is in its fully upward
position and that it remains so while you are inserting the
cable into it. Before closing the slide, ensure that the
cable is fully seated (to the white insertion line) in the
ZIF connector.