Filter
Top Products
3
Installing the Optional Monitor(s)
1. Plug all monitors into AC power outlets.
2. Turn OFF power to the monitors that will be connected to the VOPEX before connecting them.
3. Connect a monitor to the VGA MON1 port on the back of the VOPEX. See Figures 1 and 2.
Note: A monitor must be connected to the VGA MON1 port for the monitor device driver to function properly.
4. Connect any other monitors to any of the other VGA MON ports on the back of the VOPEX.
Installing the Optional Mouse(Mice)
1. Connect a mouse to the MOUSE1 port on the back of the VOPEX. See Figures 1 and 2.
2. Connect each mouse to a MOUSE port on the back of the VOPEX. Note which port number each user is attached to.
Installing the Optional Keyboard(s)
1. Connect a keyboard to the port labeled KYBD1 on the rear of the VOPEX. See Figures 1 and 2.
2. Connect the other keyboards to the back of the VOPEX, making sure that each user is connected to a Keyboard port and a
Mouse port with the same number.
MOUSE SPECIAL CONSIDERATIONS
NOTE: If the VOPEX is power-cycled with the CPU ON, the mouse driver must be reloaded for mice to function properly.
PS/2 MOUSE
1. Hot plugging limitations
A. Any mouse to be emulated must be connected to the first populated port at VOPEX power-up. e.g. If at a later time the
user wants to hot-plug 3-button mice, a 3-button mouse must have been connected in the first position at VOPEX power-
up.
B. If no mice were connected at power-up, VOPEX will default to standard 2-button mode.
2. ALPS Glidepoint
A. For “taps” function to work properly, ALPS Glidepoint must be in the first populated port on the VOPEX at power-up and
ALPS Mouse Driver must be used.
B. Some Microsoft mice may conflict with ALPS Glidepoint. If a problem occurs, connect ALPS to first populated port and
use a regular Microsoft mouse driver. NOTE: ”taps” will not function in this configuration.
3. Microsoft Ballpoint
A. Do not connect Ballpoint to the first populated port if other types of mice are to be used in the VOPEX. If Ballpoint is in
the first populated port, all other mice must also be Ballpoints.
B. At least one Ballpoint must be connected to VOPEX when powering up in order for hot-plugging to work for other
Ballpoints.
4. 3-button Mice
A. A 3-button mouse must be connected to the first populated port for any mice to work as 3-button.
5. Microsoft IntelliMouse
A. All mice connected to VOPEX must be IntelliMouse to be able to use the IntelliMouse.
B. The IntelliMouse cannot be hot-plugged.
9D SERIAL MOUSE
1. Hot-plugging
A. If no mice were connected at power-up, Mouse Systems mode will be emulated and hot-plugging Microsoft mice will not
function properly.
B. All mice connected must be set to the same mode. (Either all Mouse Systems or all Microsoft).
POWER-UP SEQUENCE
Note: Any cable longer than 100 feet for the keyboard requires an AC adapter. If using a COMPAQ keyboard, the
adapter and the VOPEX must be powered up at the same time!
1. Turn ON power to the VOPEX.
2. Turn ON power to the monitor(s).
Note: The monitor(s) MUST be turned ON before the CPU.
3. Turn ON power to the CPU.
Keyboards and mice are powered by the VOPEX.
POWER-DOWN SEQUENCE
1. Turn OFF power to the CPU.
2. Turn OFF power to the VOPEX.