Compaq 60002MC10 Computer Hardware User Manual


 
BIOS
Page 4-13
Doze Mode: The Doze mode timer starts to count when no PM events have
occurred.
Suspend Mode: This function works only when the Pentium II Processor is
installed. The timer starts to count when System Standby mode timer is timed
out and no PM Events are occurring. Valid range is from 1 minute up to 1 hour.
HDD Power Down: HDD Standby timer can be set from 1 to 15 minute(s).
Soft-Off by PWRBTN: Use this to select your soft-off function.
The default is Delay 4 sec.
Instant Off: Turns off instantly.
Delay 4 Second: Turns off after a 4 second delay. If momentary press of button,
the system will go into Suspend Mode. Press again to take
system out of Suspend Mode.
PWRON After PW-Fail: The system will stay of or power on after a power
interrupte. The default is OFF.
Fomer-Status: Stay off or power on depend on system safe shut-down or power
fail.
ON: System always power on after a power interrupte.
OFF: System always stay off after a power interrupte.
VGA: When set to On (default), any event occurring at a VGA port will awaken a
system which has been powered down.
LPT & COM: When set to On (default), any event occurring at a COM(serial)/
LPT (printer) port will awaken a system which has been powered down.
HDD & FDD: When set to On (default), any event occurring at a hard or floppy
drive port will awaken a system which has been powered down.
DMA/master: When set to On (default), any event occurring to the DMA control-
ler will awaken a system which has been powered down.
RTC Alarm Resume: When set to Enable rta alarm resume, you could set the
date (of month) and timer (hh:mm:ss), any event occurring at will awaken a system
which has been powered down.