Filter
Top Products
#define CMD_POWERUP (0x1b<<11) 31
#define CMD_POWERDOWN (0x1c<<11) 32
#define CMD_POWERAUTO (0x1d<<11) 33
1 Defines the offset for the I/O port of the command port register.
2 Defines the reset command bit position.
3 Defines the window selector for commands that are used to set up the
device.
4 Defines the window selector for commands that control the operation of
the device.
5 Defines the window selector for specifying the hardware address of
the device.
6 Defines the window selector for the device’s first-in/first-out (FIFO)
buffer.
7 Defines the window selector for commands that are used for diagnostic
purposes.
8 Defines a second window selector for commands that are used for
diagnostic purposes.
9 Defines the window selector for commands that are related to gathering
device statistics.
10 Defines the start 10Base2 Ethernet cable command.
11 Defines the receive (RX) disable command.
12 Defines the receive (RX) enable command.
13 Defines the receive (RX) reset command.
14 Defines the receive (RX) discard top packet command.
15 Defines the transmit (TX) enable command.
16 Defines the transmit (TX) disable command.
17 Defines the transmit (TX) reset command.
18 Defines the request interrupt command.
19 Defines the acknowledge interrupt command.
20 Defines the set interrupt mask command.
21 Defines the clear interrupt command.
22 Defines the receive (RX) filter command.
Defining Device Register Offsets 2–3