Filter
Top Products
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
3
Compaq Netelligent 1005 10Base-T Hub User Guide
Writer:
Chris Seiter
Project:
Netelligent 1005 10Base-T Hub User Guide
Comments:
File Name:
1005.DOC
Last Saved On:
6/26/97 11:19 AM
RJ-45 Ports
There are five RJ-45 MDI-X station ports and one RJ-45 MDI uplink port, each
providing a 10 Mb/s Ethernet channel. To connect to a workstation or server,
attach straight-through unshielded or shielded twisted-pair cabling to any station
port.
To connect to another Netelligent 1005 or compatible hub, attach straight-
through twisted-pair cabling to the UPLINK port. You can also connect to
another hub by running straight-through twisted-pair cabling from a station port
on this hub to a crossover port on the other hub. However, if you must connect
to another hub via stations ports at both ends of the cable, use crossover cabling.
NOTE
: Using the UPLINK port disables Port 5.
Power Connector
The power adapter plugs into this connector. The power adapter plugs into the
main AC power source at 100V, 120V, 220-230V, or 240V at 50 to 60Hz.
Installing the Hub
This section describes different ways of using the supplied hub stand and
explains how to attach the hub to devices in your network.
Using the Hub Stand
You can attach and use the hub stand in the following ways:
Q
To stand the hub upright on a desk or shelf, slide the stand onto the base
of the hub.
Q
To lay the hub flat, slide the stand onto the back of the hub.
Q
To mount the hub directly on a wall or office partition, first attach the
stand to the mounting location with two small screws. Then slide the
back of the hub onto the stand.